This Hot-Dipped Galvanized Torsion Axle Assembly comes completely assembled with 5 lug Galvanized Hubs, ready to be installed to your trailer's 72 inch wide I Beam Frame. This V-Bend Axle features Posi-Lube Spindles which makes Bearing Maintenance a Breeze. Looking for a new Boat Trailer Torsion Axle has never been easier, we've included all the measurements below, but the most important measurement is your Galvanized or Aluminum I-Beam Frame width, and the Trailer Axle Hub Face Measurement.
Torsion Bar Axles eliminate the need for Leaf Springs on your trailer. A new Galvanized Torsion Axle is a great upgrade to any boat trailer or utility trailer. Torsion Arm Axles feature rubber chords inside the axle which gives the trailer the suspension it needs. These rubber chords do not rust as leaf springs do, so they last much longer in marine environments. Additionally, this is the only Boat Trailer Torsion Axle on the market with a fully Hot-Dipped Galvanized Torsion Arm, making it great for freshwater boat trailers and the best Galvanized Axle for saltwater trailers. This torsion axle also has a drain hole at the bottom of the V-Bend to purge any water that gets into the tubing, further helping to prevent rust.
This Torsion Axle ships directly to your door with the Hot-Dipped Galvanized 5 lug Hubs and 1.98 inch Greaseable Dust Caps already installed. The hub studs are 1/2-20" diameter, so you would want to use a 1/2-20" diameter lug nuts. Just add your Tires & Wheels along with some Lug Nuts and your trailer will be road-ready again in no time. This particular torsion axle is designed for Fresh or Saltwater, and is made to fit I-Beam Trailer Frames that are 72 inches wide. Please Double Check all the Measurements Below to ensure this Torsion Axle is a good fit for your trailer.
I Beam Trailer Frame Width Required for This Axle Size - 72-inch Wide Trailer Frames - Measured outside to outside
Knott Torsion Axle Specifications:
Torsion Axle Track Measurement (Hub Face/Center of Tire) - 86 inches
Brake Flange - 80 inches Outside to Outside
Torsion Bracket - 74 1/2" inches Outside to Outside
Torsion Axle Starting Angle - 30 Degree Down
Standard 4 Hole Brake - can accommodate Drum or Disc Brakes (10 inch, 5 lug)
This Hot-Dipped Galvanized Torsion Axle ships with galvanized Idler hubs installed. The hubs and bearings are pre-greased with a lithium-based grease, but additional grease may be added after installation.
Galvanized Hub Specifications:
5 on 4 ½ inch Bolt Pattern
1 3/8 inch inner bearing, 1 1/16 inch outer bearing
1.72 inch inner diameter grease seal
Hot-Dipped Galvanized
1.98 dust cap size, dust cap is included and has a removable rubber plug for easy addition of grease
If you need to replace the mounting hardware as well, either Click the Check Box for (4) I Beam Torsion Axle Mounting Bolts SS, or Go to 1/2 inch Diameter by 1 1/2 inch Long Stainless Steel Bolt and order the quantity you need (typically 4 total per axle.)
New Mounting Holes May need to be drilled in order to install the new axle.
These Axles can be used on Continental Boat Trailers, Magic Tilt Trailers, Loadmaster Trailers, Float On Trailers, and many others.
