This DOT Approved Flexible Rubber Brake hose is UV resistant and features a 90 Degree Fitting on one of the ends. This 90 Degree fitting can be used to connect your brake lines where a straight fitting would not be able to reach. The Rubber Trailer Brake Line is UV resistant which makes it ideal for Boat Trailers as well as Utility Trailers. A Hydraulic Trailer Hose of this length would normally be used to connect to the other Caliper across an axle, but it can be positioned anywhere on your trailer that it is needed.
Most trailer Brake Components on the market will be compatible with this Trailer Brake Line, which uses the standard 3/16" Male inverted Flare ends and a 3/8"- 24 thread size. One of the fittings on this Flexible Line has a 90 degree angle which helps to install this Hydraulic line in otherwise tight or tough to reach places on your Trailer. While The Brake Line is flexible, it cannot bend at a sharp angle like 90 degrees without causing a blockage in the line. The Stainless Steel insert is able to bend at that angle without restricting the Brake Pressure. The Brass fitting is secured on the Bend and can be tightened to your Caliper or other brake components just as a straight fitting would. If your trailer's brake set up is not in need of a hose with a 90 degree bend like this one, we have many other Hydraulic Trailer Lines available for sale on our store at this link.
-74" Flexible Hose
-90 Degree Fitting on 1 End
-3/16" Male inverted Flare
-3/8"-24 Thread Size
-Brass Fittings and Stainless Steel Insert