This rust-resistant zinc finish 2,500-pound capacity boat trailer jack is ideal for boat or jet ski trailers in marine environments. If the old trailer jack on your freshwater or saltwater boat trailer is ugly, corroded, and difficult to crank, this jack is the perfect solution! The zinc-plated finish is corrosion-resistant to increase the longevity and durability of this jack, and the easy to use greaseable zerk fitting allows you to lubricate the jack's gear housing as necessary to keep it easy to jack up and down. This jack is frequently seen on boat trailers with boats ranging from 20 to 30 feet and is sometimes mounted with two jacks on either side of the tongue to increase capacity and to increase the stability of the trailer when not attached to a towing vehicle.
This square 2.5k capacity zinc jack comes with a pre-welded mounting plate, allowing you to mount this jack to a variety of different trailers. The mounting plate accommodates trailer tongues measuring 2 inches to 5 inches in height, and up to 3 inches in width. The 7 1/2 inch x 3 3/4 inch drop foot is also suitable for a variety of different surfaces, from hard asphalt to soft dirt. The jack is covered by a 1-year warranty, so you know you will be receiving a reliable product that is ready to mount to your boat trailer right out of the box!
- 2,500 pound capacity
- Fits frames 2" to 5" in height and up to 3" in width
- Lift height from 7 1/4" to 22 5/8"
- Drop foot measures 7 1/2" by 3 3/4"
- 1 Year Warranty
- 2,500 lb capacity square boat trailer jack
- Zinc-Plated for corrosive resistance
- Includes grease fitting for greasing jack gear housing
- Bolt-On jack includes all mounting hardware