This Painted Steel Round Trailer Axle has a carrying capacity of 7,000 lbs. This is a listing for the Axle beam only. The Hubs are available separately. The Spindles are welded into the beam of the Axle as pictured. These 7000 lb Round Steel Trailer Axles are made of round steel tubing that measures 3 inches in diameter and has 1/4" wall thickness. This 7000 lb Painted Steel Trailer Axle will typically use 6 Lug or 8 Lug Trailer Hubs or Brake Drums.
This 7,000 lb Trailer Axle has #42 tapered spindles that use the following bearing sizes and grease seal size:
Inner Bearing – 25580 with 1 3/4 inch inner diameter
Outer Bearing- 15123 (6 Lug), 67048 (6 Lug), or 14125A (8 Lug) with or 1 1/4 inch inner diameter
Grease Seal- 2.25 inches inner diameter
Each 7,000 lb Painted Steel Trailer Axle we sell is equipped with the Standard 5 Hole Brake Flange for mounting Trailer Brakes. The Castle Nut and Spindle Washer are included with the axle. Some of our Painted Steel Trailer Axles come with Pre-Mounted Spring Seats for specific measurements. The Axles listed without pre-mounted spring seats will include the spring seats for you, the customer to weld to your specific measurements. It is very important that you do not weld your spring seats outside the range listed. Using an axle to long may cause a leverage issue, leading to pre-mature bending or damaging to the ends of the axle. An axle that is to short will cause the tires to rub on the frame of the trailer.
Check the Hub Face Measurement and overall measurement below, as well as the if the Axle comes with pre-mounted spring seats.
Hub face measures: 89 inches
-Hub Face measurement refers to the outside face measurement, from one trailer hub across the axle to the outside face of the trailer hub across from it. This is also referred to as the Center of Tire Measurement, or Track Measurement
Brake Flange Measurement: 83 inches
-Refers to the Outside of One Brake Flange across the Axle to the Outside of the opposing Brake Flange
Overall length measures: 95 inches
Spring Seats Are Welded to This Axle: 74" Center to Center Leaf Spring
Camber: Cambered, Axle Camber is intended for use with Leaf springs mounted below the axle.
